Skip to content
RuneSpool

Online shop opening soon

QR plates for your counter, printed with your logo.

RuneSpool is a small 3D-printing workshop. We draw each plate around your brand, make sure every line will print and the QR code scans, and print it layer by layer in PLA.

See the plates Message us on Instagram
0.4 mm nozzle · 18 layers

Plates we've printed

Photos of the real plates, not renders. Three of them belong to businesses that let us show their plate here.

Our own logo plate on its black stand, seen from the front: a black rune logo with an orange dot, raised letters and a QR code on a white plate
RuneSpoolOur own plate. Black relief on white.
The same plate seen from the side, showing the raised letters and the stand
RuneSpool, from the sideThe letters stand 0.6 mm off the plate.
A logo plate with white letters and QR code on black, with a lilac frame and logo, on a black stand
HechizoLabWhite on black, with a lilac frame.
A lilac logo plate: a white hot-air balloon logo, a script name and a QR code, on a light stand
Laberinto MágicoIvory relief on lilac, on a light stand.
A magenta logo plate: a white monogram, the studio name and a QR code, on a black stand
Andrea Torres Estudio CreativoAn ivory monogram on plum.
Side view of a RuneSpool QR plate in its stand The plate is 4 mm thick and leans back 15 degrees in a slot cut into a wedge-shaped stand, 48 mm deep, 5 mm tall at the front and 12 mm at the back. 15° 48 mm 12 mm 5 mm 4 mm plate 0.6 mm relief

Every number comes from the printer.

A 0.4 mm nozzle can't draw a line much thinner than 0.9 mm, so we check each letter and each square of the QR code against that before anything prints. The plate leans back in a wedge stand, which hides its lower edge and keeps it steady on a counter.

Plate
90 × 140 × 4 mm, rounded corners
Relief
Letters, logo and QR raised 0.6 mm
Stand
102 × 48 mm, 5 mm tall at the front, 12 mm at the back
Lean
15° back, in a slot that holds the bottom 9 mm
Finest line
0.9 mm, and QR squares of 2.1 mm or more
Material
PLA. It softens with heat, so keep it out of hot cars and sunny windows.

How a plate gets made

  1. You send us your logo and a link

    Your website, menu, Instagram or review page: whatever the QR code should open.

  2. We design it and show you a render

    You see the plate with your colors before anything prints.

  3. We print it and scan it

    The QR code is read from the printed plate before it leaves the workshop.

The online shop opens soon.

You'll be able to type your words, pick the lettering and colors, and turn the plate around in 3D before you order. Until then, message us and we'll design yours with you.

Message us on Instagram

or write to contact@runespool.com